​Chemical centrifugal pumps with gaskets
​We offer conventional chemical centrifugal pumps in three variants: block pumps, standard pumps and submerged vertical pumps. They are fitted with high-quality shaft seals
Picture








​Motor pump MB
Conveying chemicals safely
The MB motor pump is a single-stage, normal-priming centrifugal pump in block design with horizontal axis. The MB pump has an open impeller for low-viscosity, acid and alkaline solutions with low solid matter content. The pump head assembly consists of high-quality plastic materials with hydraulically efficient spiral casing
Features
  • Single-stage, normal-priming pumps with horizontal axis
  • Open impeller
  • Pump head made of high-quality thick-walled plastic material
  • Corrosion-resistant
  • Wetted-end parts made of highly resistant material
  • Special varnish, stainless steel pump shaft with shaft protection sleeve
  • Shaft seals single or double-acting
  • Vibrationless operation
Picture
 








​Motor pump BN
Conveying chemicals safely
BN-type motor pump units are normal-priming, single-stage, plastic centrifugal pumps in block design with horizontal axis. Their dimensions and flow rates mainly correspond to DIN/EN 22858. The extended shaft of the drive motors directly carries the impeller. The pump head is flanged to the drive motor using an intermediate piece.
Features
  • Single-stage, normal-priming pumps with horizontal axis
  • Piping connections according to DIN EN 22858/ISO 2858
  • Corrosion-resistant
  • Wetted-end parts made of highly resistant material
  • Special varnish, stainless steel pump shaft with shaft protection sleeve
  • Mechanical seal systems depending on medium
  • Space-saving installation
  • Vibrationless operation
  • Wide range of capacity
Picture









​Standard pump N
Conveying chemicals safely
N-type standard pumps are normal-priming, single-stage, plastic centrifugal pumps with horizontal axis. Their dimensions and flow rates correspond to DIN/EN 22858. The standard use of extension coupling ensures simple dismantling of bearing supports and internal pump components without removing the pipe connections and motor. This avoids laborious alignment of the pump and motor when assembling the system.
Features
  • Single-stage, normal-priming centrifugal pump
  • Piping connections according to DIN EN 22858/ISO 2858
  • Fast and easy removal of the bearing support
  • Corrosion-resistant
  • Wetted-end parts made of highly resistant material
  • Special varnish, stainless steel pump shaft with shaft protection sleeve
  • Mechanical seal systems depending on medium
  • Perfectly dimensioned shafts and bearings
  • Lifetime lubrication of bearings in bearing support
  • Vibrationless operation
  • Wide range of capacity
Picture

















​Vertical Immersion Pump VTP BBF
Conveying chemicals safely
VTP centrifugal pumps in block design (BBF) correspond to the system of two-pipe pumps. Basically these immersion pumps are single-level immersion pumps with vertical axis the main components of which are combined according to the proven module system. The drive motor is located in the dry section above the fastening plate. The pump head is immersed in the medium.  
Features
  • Single-stage, vertical immersion pumps according to the two-pipe principle
  • Immersion pump with especially designed three-phase A.C. motor
  • Immersed section of the pump without seals
  • Corrosion-resistant
  • Wetted-end parts made of highly resistant material
  • Special varnish for motor and metal parts